Guangzhou Gangmengshangxin Intelligent Equipment Technology Co., Ltd.
Contact person: Mr. Miao
Phone number: 13318838881
QQ: 443224069
E-mail address: 443224069@qq.com
Website: www.gz-gmsx.com
Address: Room 15, 24F, CCC Gangwan International Building (No. 68), Gangwan Road, Huangpu District, Guangzhou, China
No matter what we use, the operation method should be correct, especially when using the labelling machine, so that there will be no problems in the process of use, which can improve the efficiency. It is understood that periodic labeling machine faults are separated by a certain number of containers will appear the same abnormal labeling situation. The cause of recurrent defects is the abnormal symptoms of a labelling device or a part on a transmitting device, according to which the problematic part can be found. The damage of the body mark, the label skew, no glue on one side of the label, no glue on one side of the label and any other part of the label may lead to periodic problems of the labeling machine.
1. The periodic symptoms of body mark damage caused by body mark damage are mostly caused by the disc at the outlet star wheel. Specifically, one or several grooves in the upper disc of the outlet star wheel are now showing cracks, spines, deformation, wear, etc., which will tear, tear, wrinkle, bump the upper part of the body mark. Similarly, problems with one or more grooves in the lower disk of the outlet star wheel will damage the lower part of the body mark. In addition, foreign matter between the upper and lower roulette wheel can damage the body mark. In general, the back is smaller than the body, so the back is less likely to be damaged by an outlet star wheel.
Label skew periodic label skew symptoms are most often caused by parts above the drum.
The reasons can be found from the following parts:
1. Scratch label clip refers to the following pad condition or abnormal adjustment. For example: the pad is worn; The gap between the pad and the palm is too large or too small; The pad does not work well with the pinch finger, etc.
2. Scratch label and clip finger to glue liquid or maladjusted. For example, one clip is able to hold the label, and another clip is not able to hold the label; The clip finger is not in the center of the mark palm groove; Incorrect opening or closing time of clip finger; Clip fingers do not work well with the pad, etc.
3. Sponge pushing block sticks adhesive liquid or wears and deforms.
The clip spring on one of the grip fingers is now cracked or stuck.
5. The cardan axis of labeling station is not installed correctly, that is, the mark on the cardan axis is not right.
Guangzhou Gangmengshangxin Intelligent Equipment Technology Co., Ltd.
Contact person: Mr. Miao
Phone number: 13318838881
QQ: 443224069
E-mail address: 443224069@qq.com
Website: www.gz-gmsx.com
Address: Room 15, 24F, CCC Gangwan International Building (No. 68), Gangwan Road, Huangpu District, Guangzhou, China