Guangzhou Gangmengshangxin Intelligent Equipment Technology Co., Ltd.
Contact person: Mr. Miao
Phone number: 13318838881
QQ: 443224069
E-mail address: 443224069@qq.com
Website: www.gz-gmsx.com
Address: Room 15, 24F, CCC Gangwan International Building (No. 68), Gangwan Road, Huangpu District, Guangzhou, China
Nowadays, we all use machinery to do our work, so there are many automatic labeling machines around us. As far as we know, when we use automatic labeling machines to attach sticker labels, we sometimes encounter the situation that the label position is unstable and slightly offset. What's the reason? , labelling machine work when labelling position instability how to do?
1. The pressure belt device may not be compressed, causing the label belt to become loose and the electric eye detection is forbidden. Press label processing.
2. It may be that the traction tissue is slipping or it may be uncompressed, which will not be able to smoothly take away the paper. Press and pull the tissue to handle, too tight situation will pull the label, to be able to pull the bottom paper for the best. (in general, if the paper is pulled out when wrinkled, it should be pressed too tightly.)
3. The shape of the object to be attached may differ from the location. Control product quality.
4. The object to be attached should be placed in parallel with the direction of the labeling (pay attention to whether the product is positioned in the labeling process, and the support bar on the left side can be improved a little bit more than on the right side)
5. The attached object should be sure to roll smoothly on the label position (be careful not to touch the marking plate). If the object is too light, the overlaying pole should be put down and the pasted object should be pressed
6. Under the condition of double labeling, after the label is released by the labelling machine (1), the workpiece will keep rolling, because there is no delay for the second label and the machine is waiting for the second label label signal. (2) after the single label is issued, the work piece stops. The reason is that the probe sensor has signal interference (reset the probe), or maybe it is the abnormal delay control (click two times to move 2, then click two times to move 1).
Guangzhou Gangmengshangxin Intelligent Equipment Technology Co., Ltd.
Contact person: Mr. Miao
Phone number: 13318838881
QQ: 443224069
E-mail address: 443224069@qq.com
Website: www.gz-gmsx.com
Address: Room 15, 24F, CCC Gangwan International Building (No. 68), Gangwan Road, Huangpu District, Guangzhou, China